Insights & Industry News

Buying a Class IV fiber laser is the easy part of FP-300 ownership. The hard part is integrating it into a regulated maintenance environment — Safety Management System mapping, FAA / EASA / OSHA / FDA compliance, recordkeeping, audits, and operator training. Here's the full SMS integration service we deliver alongside every FP-300 sale, and why we built it that way.

A publicly-shared video from a competing laser-cleaning vendor shows a turbine blade with visible surface marking after cleaning. We asked Google Gemini to evaluate the image cold — without telling it our position. The AI's analysis aligns exactly with what FAA-trained inspectors look for. Here's what those marks mean, why they matter, and what proper laser cleaning is supposed to look like.

An honest look at one shop's books before and after the FP-300. Annual savings of $194,900, payback in 27 days, and a 4,802% five-year ROI — with the line items that drove every number.

Engine cowlings, exhaust stacks, and APU bays accumulate baked-on carbon deposits that resist solvents and damage media. The FP-300's pulsed energy lifts them off cleanly — here's how.

Plastic media. Aluminum oxide. Walnut shells. Every blasting medium leaves something behind — in the part, the air, the wash-water, and the disposal stream. Here's why hangar managers are eliminating media entirely.

Three rivets failed on a routine inspection — not from age, but from years of chemical pooling under the heads. Here's how laser cleaning eliminates the failure mode that took years to find.

Carbon fiber and fiberglass parts can be laser-cleaned safely — but the parameter window is much tighter than aluminum. Cross the threshold and you expose fibers; below it and resin won't ablate cleanly.

AC 43.13-1B doesn't list laser cleaning by name — because the document predates affordable fiber laser technology. Here's how to document a laser process as an acceptable method under the existing guidance.

MIL-C-81706 conversion coatings are the bridge between cleaning and primer. Miss the 8-hour application window and you've created a corrosion site — even if the surface looks fine.

Eight steps from inspection to release: how to assess pit depth, choose the right removal method, stay within SRM limits, and document the work for your DAR.

Chemical stripping leaves surfaces too smooth. Media blasting leaves them too rough. Laser cleaning lands in the Goldilocks zone — and the result is a measurable 30% improvement in primer adhesion.

The FP-300 is a Class IV laser — the same classification as surgical lasers and military targeting systems. Here's what that actually means in a hangar environment, and why proper engineering controls matter more than PPE.

Too little fluence leaves paint behind. Too much damages the substrate. The sweet spot is narrower than you'd think — and it's the same window Boeing identified for BMS10-11 primer removal.

Why does the FP-300 strip primer at 5 J/cm² yet leave bare 2024-T3 untouched at the same fluence? The answer comes down to absorption coefficients — and a 12.5× safety margin built into the physics.

The history of laser cleaning in aviation is a story of three generations — and why the third one finally made the technology practical for hangars and repair stations worldwide.